Aluminum alloy nail with solar spike installation instructions

Aluminum alloy nail with solar spike installation instructions

first, [Specifications]: 122 * 132 * 70MM, reflective film yellow, white, red, green, blue species.

Second, [installation location]: installed in the edge of the road, at night flashing light on the driver from the warning effect, to remind carefully driving.

Three, [material tools to prepare]: A glue (color transparent), B glue (color brown), cement, steel brush, scraper, chalk, tape, and plastic bucket, and glue stick, broom, the temperature is less than 10 degrees Prepare kerosene furnace and other heating tools. Drill and 28% drill, with a stick or an electric drill.

Fourth, [installation process]:
1, positioning: spike installation to smooth, dry and dry, clean, seamless.

2, mixed with plastic: spike special A glue, spike special B plastic, A plastic B glue ratio is 1: 1 (such as: A glue 1 kg, B glue is 1 kg), and then add 20% of the cement Fillers. Glue must be stirred evenly, consistent color.

3, punch: drill with a good position in the hole, hole depth 10CM.

4 with glue: the ground clean, with plastic to be moderate, both sticky road signs bottom, and do not spill too much, out of the plastic can be used scraper blowing, can be used repeatedly, stick to the left and right after two More evenly paste the ground and the nail body.

5 tour: two hours after the installation of the spike should be checked again, the occurrence of crooked, should be reversed.

6 Road: must seal road 6 hours to ensure that the glue curing time.

Five [Note]:

1, traffic safety: construction workers must be safe and reflective lighting, with anti-reflective roadblock facilities to block the construction area, the night construction of electronic light-emitting diversion card or warning lights and other signs to play a security warning effect.

2, do not install the spike on the marking, should be installed on the outside of the marking line from the mark 5cm.

3, each mixing glue shall not exceed 3 kg (because the glue after mixing in a certain period of time will be solidified, in order to avoid waste, do not mix more than 3 kg of plastic)

4, the temperature is less than 10 degrees, glue is not easy and dynamic, available kerosene furnace heating glue (heating A glue, B glue can not heat). Stir well with a stirrer.

5, in general, the spike with the same line of color, single-sided reflective film and the direction of the car relative, do not press the anti-crooked.

6, the installation process, should seize the spike on both sides, do not touch the surface of the reflective film, so as not to stick in the hands of the glue stained reflective film.

7, the road with water can not be built.


Established in 2006, “Shenzhen Lu ming Traffic Equipment Co., Ltd” was definited as an export-oriented high technology enterprise that specialize in solar traffic safety facilities’ R&D and sale over 10 years.

Our main products include: solar road studs, solar LED delineators, road reflectors, solar traffic safety signs, LED tunnel signs, traffic warning lights, solar traffic lights, anti-glare boards, solar LED anti-bump barriers, parking lot safety facilities etc.

Shenzhen LuMing Traffic Equipment Co., Ltd.

TEL:     0086 755 27708545

MOB:     0086  13925263646

FAX:     0086 755 27701581

EMAIL: szlm@szlmjt.com

ADD: 3F, Building 1, Futing Industrial Zone, Guanlan Street, Longhua New District, Shenzhen

POST CODE: 518110

WEBSITES：

https://szlm9.1688.com/(China)
https://szlmjt.en.alibaba.com(English)